Revert "SoftwareSerial library to the new format"

This reverts commit 38c3bbbd3c83eda057d4857635fbd78a4785c3a4.

1 files changed, 55 insertions, 0 deletions

diff --git a/libraries/SoftwareSerial/examples/SoftwareSerialExample/SoftwareSerialExample.ino b/libraries/SoftwareSerial/examples/SoftwareSerialExample/SoftwareSerialExample.ino
new file mode 100644
index 0000000..f659133
--- /dev/null
+++ b/libraries/SoftwareSerial/examples/SoftwareSerialExample/SoftwareSerialExample.ino
@@ -0,0 +1,55 @@
+/*
+  Software serial multple serial test
+
+ Receives from the hardware serial, sends to software serial.
+ Receives from software serial, sends to hardware serial.
+
+ The circuit:
+ * RX is digital pin 10 (connect to TX of other device)
+ * TX is digital pin 11 (connect to RX of other device)
+
+ Note:
+ Not all pins on the Mega and Mega 2560 support change interrupts,
+ so only the following can be used for RX:
+ 10, 11, 12, 13, 50, 51, 52, 53, 62, 63, 64, 65, 66, 67, 68, 69
+
+ Not all pins on the Leonardo support change interrupts,
+ so only the following can be used for RX:
+ 8, 9, 10, 11, 14 (MISO), 15 (SCK), 16 (MOSI).
+
+ created back in the mists of time
+ modified 25 May 2012
+ by Tom Igoe
+ based on Mikal Hart's example
+
+ This example code is in the public domain.
+
+ */
+#include <SoftwareSerial.h>
+
+SoftwareSerial mySerial(10, 11); // RX, TX
+
+void setup()
+{
+  // Open serial communications and wait for port to open:
+  Serial.begin(57600);
+  while (!Serial) {
+    ; // wait for serial port to connect. Needed for Leonardo only
+  }
+
+
+  Serial.println("Goodnight moon!");
+
+  // set the data rate for the SoftwareSerial port
+  mySerial.begin(4800);
+  mySerial.println("Hello, world?");
+}
+
+void loop() // run over and over
+{
+  if (mySerial.available())
+    Serial.write(mySerial.read());
+  if (Serial.available())
+    mySerial.write(Serial.read());
+}
+