1 files changed, 0 insertions, 55 deletions
diff --git a/libraries/SoftwareSerial/examples/SoftwareSerialExample/SoftwareSerialExample.ino b/libraries/SoftwareSerial/examples/SoftwareSerialExample/SoftwareSerialExample.ino
deleted file mode 100644
index 6101bb1..0000000
--- a/libraries/SoftwareSerial/examples/SoftwareSerialExample/SoftwareSerialExample.ino
+++ /dev/null
@@ -1,55 +0,0 @@
-/*
-  Software serial multple serial test
- 
- Receives from the hardware serial, sends to software serial.
- Receives from software serial, sends to hardware serial.
- 
- The circuit: 
- * RX is digital pin 10 (connect to TX of other device)
- * TX is digital pin 11 (connect to RX of other device)
- 
- Note:
- Not all pins on the Mega and Mega 2560 support change interrupts, 
- so only the following can be used for RX: 
- 10, 11, 12, 13, 50, 51, 52, 53, 62, 63, 64, 65, 66, 67, 68, 69
- 
- Not all pins on the Leonardo support change interrupts, 
- so only the following can be used for RX: 
- 8, 9, 10, 11, 14 (MISO), 15 (SCK), 16 (MOSI).
- 
- created back in the mists of time
- modified 25 May 2012
- by Tom Igoe
- based on Mikal Hart's example
- 
- This example code is in the public domain.
- 
- */
-#include <SoftwareSerial.h>
-
-SoftwareSerial mySerial(10, 11); // RX, TX
-
-void setup()  
-{
-  // Open serial communications and wait for port to open:
-  Serial.begin(57600);
-  while (!Serial) {
-    ; // wait for serial port to connect. Needed for Leonardo only
-  }
-
-
-  Serial.println("Goodnight moon!");
-
-  // set the data rate for the SoftwareSerial port
-  mySerial.begin(4800);
-  mySerial.println("Hello, world?");
-}
-
-void loop() // run over and over
-{
-  if (mySerial.available())
-    Serial.write(mySerial.read());
-  if (Serial.available())
-    mySerial.write(Serial.read());
-}
-