1 files changed, 0 insertions, 53 deletions
diff --git a/libraries/Bridge/examples/ShellCommands/ShellCommands.ino b/libraries/Bridge/examples/ShellCommands/ShellCommands.ino
deleted file mode 100644
index 5a4c291..0000000
--- a/libraries/Bridge/examples/ShellCommands/ShellCommands.ino
+++ /dev/null
@@ -1,53 +0,0 @@
-/*
-  Running shell commands using Process class. 
- 
- This sketch demonstrate how to run linux shell commands
- using an Arduino Yún. It runs the wifiCheck script on the linino side
- of the Yun, then uses grep to get just the signal strength line.
- Then it uses parseInt() to read the wifi signal strength as an integer,
- and finally uses that number to fade an LED using analogWrite().
- 
- The circuit:
- * Arduino Yun with LED connected to pin 9
- 
- created 12 Jun 2013
- by Cristian Maglie
- modified 25 June 2013
- by Tom Igoe
- 
- This example code is in the public domain.
- 
- */
-
-#include <Process.h>
-
-void setup() {
-  Bridge.begin();	// Initialize the Bridge
-  Serial.begin(9600);	// Initialize the Serial
-
-  // Wait until a Serial Monitor is connected.
-  while(!Serial);
-}
-
-void loop() {
-  Process p;
-  // This command line runs the WifiStatus script, (/usr/bin/pretty-wifi-info.lua), then 
-  // sends the result to the grep command to look for a line containing the word
-  // "Signal:"  the result is passed to this sketch:
-  p.runShellCommand("/usr/bin/pretty-wifi-info.lua | grep Signal");
-
-  // do nothing until the process finishes, so you get the whole output:
-  while(p.running());  
-
-  // Read command output. runShellCommand() should have passed "Signal: xx&":
-  while (p.available()) {
-    int result = p.parseInt();			// look for an integer
-    int signal = map(result, 0, 100, 0, 255);	// map result from 0-100 range to 0-255
-    analogWrite(9, signal);			// set the brightness of LED on pin 9
-    Serial.println(result);			// print the number as well
-  } 
-  delay(5000);  // wait 5 seconds before you do it again
-}
-
-
-