Merged upstream Arduino master branch

1 files changed, 17 insertions, 7 deletions

diff --git a/libraries/SoftwareSerial/examples/SoftwareSerialExample/SoftwareSerialExample.ino b/libraries/SoftwareSerial/examples/SoftwareSerialExample/SoftwareSerialExample.ino
index 69bcc01..6101bb1 100644
--- a/libraries/SoftwareSerial/examples/SoftwareSerialExample/SoftwareSerialExample.ino
+++ b/libraries/SoftwareSerial/examples/SoftwareSerialExample/SoftwareSerialExample.ino
@@ -5,11 +5,20 @@
  Receives from software serial, sends to hardware serial.
  
  The circuit: 
- * RX is digital pin 2 (connect to TX of other device)
- * TX is digital pin 3 (connect to RX of other device)
+ * RX is digital pin 10 (connect to TX of other device)
+ * TX is digital pin 11 (connect to RX of other device)
+ 
+ Note:
+ Not all pins on the Mega and Mega 2560 support change interrupts, 
+ so only the following can be used for RX: 
+ 10, 11, 12, 13, 50, 51, 52, 53, 62, 63, 64, 65, 66, 67, 68, 69
+ 
+ Not all pins on the Leonardo support change interrupts, 
+ so only the following can be used for RX: 
+ 8, 9, 10, 11, 14 (MISO), 15 (SCK), 16 (MOSI).
  
  created back in the mists of time
- modified 9 Apr 2012
+ modified 25 May 2012
  by Tom Igoe
  based on Mikal Hart's example
  
@@ -18,17 +27,17 @@
  */
 #include <SoftwareSerial.h>
 
-SoftwareSerial mySerial(2, 3); // RX, TX
+SoftwareSerial mySerial(10, 11); // RX, TX
 
 void setup()  
 {
- // Open serial communications and wait for port to open:
+  // Open serial communications and wait for port to open:
   Serial.begin(57600);
-   while (!Serial) {
+  while (!Serial) {
     ; // wait for serial port to connect. Needed for Leonardo only
   }
 
-  
+
   Serial.println("Goodnight moon!");
 
   // set the data rate for the SoftwareSerial port
@@ -43,3 +52,4 @@ void loop() // run over and over
   if (Serial.available())
     mySerial.write(Serial.read());
 }
+