Merged master

1 files changed, 35 insertions, 1 deletions

diff --git a/libraries/SoftwareSerial/examples/SoftwareSerialExample/SoftwareSerialExample.ino b/libraries/SoftwareSerial/examples/SoftwareSerialExample/SoftwareSerialExample.ino
index 1f535bd..6101bb1 100644
--- a/libraries/SoftwareSerial/examples/SoftwareSerialExample/SoftwareSerialExample.ino
+++ b/libraries/SoftwareSerial/examples/SoftwareSerialExample/SoftwareSerialExample.ino
@@ -1,10 +1,43 @@
+/*
+  Software serial multple serial test
+ 
+ Receives from the hardware serial, sends to software serial.
+ Receives from software serial, sends to hardware serial.
+ 
+ The circuit: 
+ * RX is digital pin 10 (connect to TX of other device)
+ * TX is digital pin 11 (connect to RX of other device)
+ 
+ Note:
+ Not all pins on the Mega and Mega 2560 support change interrupts, 
+ so only the following can be used for RX: 
+ 10, 11, 12, 13, 50, 51, 52, 53, 62, 63, 64, 65, 66, 67, 68, 69
+ 
+ Not all pins on the Leonardo support change interrupts, 
+ so only the following can be used for RX: 
+ 8, 9, 10, 11, 14 (MISO), 15 (SCK), 16 (MOSI).
+ 
+ created back in the mists of time
+ modified 25 May 2012
+ by Tom Igoe
+ based on Mikal Hart's example
+ 
+ This example code is in the public domain.
+ 
+ */
 #include <SoftwareSerial.h>
 
-SoftwareSerial mySerial(2, 3);
+SoftwareSerial mySerial(10, 11); // RX, TX
 
 void setup()  
 {
+  // Open serial communications and wait for port to open:
   Serial.begin(57600);
+  while (!Serial) {
+    ; // wait for serial port to connect. Needed for Leonardo only
+  }
+
+
   Serial.println("Goodnight moon!");
 
   // set the data rate for the SoftwareSerial port
@@ -19,3 +52,4 @@ void loop() // run over and over
   if (Serial.available())
     mySerial.write(Serial.read());
 }
+