Esplora library to new format

1 files changed, 0 insertions, 55 deletions

diff --git a/libraries/Esplora/Beginners/EsploraLedShow2/EsploraLedShow2.ino b/libraries/Esplora/Beginners/EsploraLedShow2/EsploraLedShow2.ino
deleted file mode 100644
index 8f9f8a2..0000000
--- a/libraries/Esplora/Beginners/EsploraLedShow2/EsploraLedShow2.ino
+++ /dev/null
@@ -1,55 +0,0 @@
-/*
-  Esplora Led/Microphone
-
-  This simple sketch reads the microphone, light sensor, and slider.
-  Then it uses those readings to set the brightness of red, green and blue
-  channels of the RGB LED. The red channel will change with the loudness
-  "heared" by the microphone, the green channel changes as the
-  amount of light in the room and the blue channel will change
-  with the position of the slider.
-
-  Created on 22 november 2012
-  By Enrico Gueli <enrico.gueli@gmail.com>
-  Modified 24 Nov 2012
-  by Tom Igoe
-*/
-
-#include <Esplora.h>
-
-void setup() {
-  // initialize the serial communication:
-  Serial.begin(9600);
-}
-
-int lowLight = 400;   // the light sensor reading when it's covered
-int highLight = 1023; // the maximum light sensor reading 
-int minGreen = 0;     // minimum brightness of the green LED
-int maxGreen = 100;   // maximum brightness of the green LED
-
-void loop() {
-  // read the sensors into variables:
-  int mic = Esplora.readMicrophone();
-  int light = Esplora.readLightSensor();
-  int slider = Esplora.readSlider();
-  
-  // convert the sensor readings to light levels:
-  byte red   = constrain(mic, 0, 255);
-  byte green = constrain(
-                  map(light, lowLight, highLight, minGreen, maxGreen),
-                  0, 255);
-  byte blue  = slider/4;
-
-  // print the light levels (to see what's going on):
-  Serial.print(red);
-  Serial.print(' ');
-  Serial.print(green);
-  Serial.print(' ');
-  Serial.println(blue);
-
-  // write the light levels to the LED. 
-  // note that the green value is always 0:
-  Esplora.writeRGB(red, green, blue);
-  
-  // add a delay to keep the LED from flickering:
-  delay(10); 
-}