/* WiFi UDP Send and Receive String This sketch wait an UDP packet on localPort using a WiFi shield. When a packet is received an Acknowledge packet is sent to the client on port remotePort Circuit: * WiFi shield attached created 30 December 2012 by dlf (Metodo2 srl) */ #include #include #include int status = WL_IDLE_STATUS; char ssid[] = "yourNetwork"; // your network SSID (name) char pass[] = "secretPassword"; // your network password (use for WPA, or use as key for WEP) int keyIndex = 0; // your network key Index number (needed only for WEP) unsigned int localPort = 2390; // local port to listen on char packetBuffer[255]; //buffer to hold incoming packet char ReplyBuffer[] = "acknowledged"; // a string to send back WiFiUDP Udp; void setup() { //Initialize serial and wait for port to open: Serial.begin(9600); while (!Serial) { ; // wait for serial port to connect. Needed for Leonardo only } // check for the presence of the shield: if (WiFi.status() == WL_NO_SHIELD) { Serial.println("WiFi shield not present"); // don't continue: while(true); } // attempt to connect to Wifi network: while ( status != WL_CONNECTED) { Serial.print("Attempting to connect to SSID: "); Serial.println(ssid); // Connect to WPA/WPA2 network. Change this line if using open or WEP network: status = WiFi.begin(ssid); // wait 10 seconds for connection: delay(10000); } Serial.println("Connected to wifi"); printWifiStatus(); Serial.println("\nStarting connection to server..."); // if you get a connection, report back via serial: Udp.begin(localPort); } void loop() { // if there's data available, read a packet int packetSize = Udp.parsePacket(); if(packetSize) { Serial.print("Received packet of size "); Serial.println(packetSize); Serial.print("From "); IPAddress remoteIp = Udp.remoteIP(); Serial.print(remoteIp); Serial.print(", port "); Serial.println(Udp.remotePort()); // read the packet into packetBufffer int len = Udp.read(packetBuffer,255); if (len >0) packetBuffer[len]=0; Serial.println("Contents:"); Serial.println(packetBuffer); // send a reply, to the IP address and port that sent us the packet we received Udp.beginPacket(Udp.remoteIP(), Udp.remotePort()); Udp.write(ReplyBuffer); Udp.endPacket(); } } void printWifiStatus() { // print the SSID of the network you're attached to: Serial.print("SSID: "); Serial.println(WiFi.SSID()); // print your WiFi shield's IP address: IPAddress ip = WiFi.localIP(); Serial.print("IP Address: "); Serial.println(ip); // print the received signal strength: long rssi = WiFi.RSSI(); Serial.print("signal strength (RSSI):"); Serial.print(rssi); Serial.println(" dBm"); }