From a5d1990afdd4d783b4623e4ced8833d3e1a764ae Mon Sep 17 00:00:00 2001 From: Cristian Maglie Date: Thu, 14 Nov 2013 19:52:00 +0100 Subject: Revert "SoftwareSerial library to the new format" This reverts commit 38c3bbbd3c83eda057d4857635fbd78a4785c3a4. --- .../SoftwareSerialExample.ino | 55 ++++++++++++++++++++++ 1 file changed, 55 insertions(+) create mode 100644 libraries/SoftwareSerial/examples/SoftwareSerialExample/SoftwareSerialExample.ino (limited to 'libraries/SoftwareSerial/examples/SoftwareSerialExample/SoftwareSerialExample.ino') diff --git a/libraries/SoftwareSerial/examples/SoftwareSerialExample/SoftwareSerialExample.ino b/libraries/SoftwareSerial/examples/SoftwareSerialExample/SoftwareSerialExample.ino new file mode 100644 index 0000000..f659133 --- /dev/null +++ b/libraries/SoftwareSerial/examples/SoftwareSerialExample/SoftwareSerialExample.ino @@ -0,0 +1,55 @@ +/* + Software serial multple serial test + + Receives from the hardware serial, sends to software serial. + Receives from software serial, sends to hardware serial. + + The circuit: + * RX is digital pin 10 (connect to TX of other device) + * TX is digital pin 11 (connect to RX of other device) + + Note: + Not all pins on the Mega and Mega 2560 support change interrupts, + so only the following can be used for RX: + 10, 11, 12, 13, 50, 51, 52, 53, 62, 63, 64, 65, 66, 67, 68, 69 + + Not all pins on the Leonardo support change interrupts, + so only the following can be used for RX: + 8, 9, 10, 11, 14 (MISO), 15 (SCK), 16 (MOSI). + + created back in the mists of time + modified 25 May 2012 + by Tom Igoe + based on Mikal Hart's example + + This example code is in the public domain. + + */ +#include + +SoftwareSerial mySerial(10, 11); // RX, TX + +void setup() +{ + // Open serial communications and wait for port to open: + Serial.begin(57600); + while (!Serial) { + ; // wait for serial port to connect. Needed for Leonardo only + } + + + Serial.println("Goodnight moon!"); + + // set the data rate for the SoftwareSerial port + mySerial.begin(4800); + mySerial.println("Hello, world?"); +} + +void loop() // run over and over +{ + if (mySerial.available()) + Serial.write(mySerial.read()); + if (Serial.available()) + mySerial.write(Serial.read()); +} + -- cgit v1.2.3-18-g5258