From a1f48d22ac570f0ded6db46c0d4eef0c7216a028 Mon Sep 17 00:00:00 2001 From: Fede85 Date: Tue, 2 Jul 2013 21:23:59 +0200 Subject: modifide comments in Yun examples ShellCommands.ino ConsolePixel.ino --- .../Bridge/examples/ShellCommands/ShellCommands.ino | 20 +++++++++++--------- 1 file changed, 11 insertions(+), 9 deletions(-) (limited to 'libraries/Bridge/examples/ShellCommands') diff --git a/libraries/Bridge/examples/ShellCommands/ShellCommands.ino b/libraries/Bridge/examples/ShellCommands/ShellCommands.ino index d2f9b7a..aabd0ec 100644 --- a/libraries/Bridge/examples/ShellCommands/ShellCommands.ino +++ b/libraries/Bridge/examples/ShellCommands/ShellCommands.ino @@ -1,6 +1,6 @@ /* - Running shell coommands using Process class. + Running shell commands using Process class. This sketch demonstrate how to run linux shell commands using an Arduino Yún. It runs the wifiCheck script on the linino side @@ -23,9 +23,11 @@ #include void setup() { - // initialize the Bridge and Serial connections: - Bridge.begin(); - Serial.begin(9600); + Bridge.begin(); // Initialize the Bridge + Serial.begin(9600); // Initialize the Serial + + // Wait until a Serial Monitor is connected. + while(!Serial); } void loop() { @@ -40,12 +42,12 @@ void loop() { // Read command output. runShellCommand() should have passed "Signal: xx&": while (p.available()) { - int result = p.parseInt(); // look for an integer - int signal = map(result, 0, 100, 0, 255); // map result from 0-100 range to 0-255 - analogWrite(9, signal); // set the brightness of LED on pin 9 - Serial.println(result); // print the number as well + int result = p.parseInt(); // look for an integer + int signal = map(result, 0, 100, 0, 255); // map result from 0-100 range to 0-255 + analogWrite(9, signal); // set the brightness of LED on pin 9 + Serial.println(result); // print the number as well } - delay(5000); // wait 5 seconds before you do it again + delay(5000); // wait 5 seconds before you do it again } -- cgit v1.2.3-18-g5258