From f1cd85da7ad0030d1fb1102aa9e3119851e1c4aa Mon Sep 17 00:00:00 2001 From: Matthijs Kooijman Date: Thu, 18 Apr 2013 19:06:00 +0200 Subject: Disable the UDRE interrupt sooner in HardwareSerial Before, the interrupt was disabled when it was triggered and it turned out there was no data to send. However, the interrupt can be disabled already when the last byte is written to the UART, since write() will always re-enable the interrupt when it adds new data to the buffer. Closes: #1008 --- cores/arduino/HardwareSerial.cpp | 24 ++++++++++++------------ 1 file changed, 12 insertions(+), 12 deletions(-) (limited to 'cores/arduino/HardwareSerial.cpp') diff --git a/cores/arduino/HardwareSerial.cpp b/cores/arduino/HardwareSerial.cpp index ffdb82c..9a02f23 100644 --- a/cores/arduino/HardwareSerial.cpp +++ b/cores/arduino/HardwareSerial.cpp @@ -223,22 +223,22 @@ void HardwareSerial::_rx_complete_irq(void) void HardwareSerial::_tx_udr_empty_irq(void) { + // If interrupts are enabled, there must be more data in the output + // buffer. Send the next byte + unsigned char c = _tx_buffer[_tx_buffer_tail]; + _tx_buffer_tail = (_tx_buffer_tail + 1) % SERIAL_BUFFER_SIZE; + + *_udr = c; + + // clear the TXC bit -- "can be cleared by writing a one to its bit + // location". This makes sure flush() won't return until the bytes + // actually got written + sbi(*_ucsra, TXC0); + if (_tx_buffer_head == _tx_buffer_tail) { // Buffer empty, so disable interrupts cbi(*_ucsrb, UDRIE0); } - else { - // There is more data in the output buffer. Send the next byte - unsigned char c = _tx_buffer[_tx_buffer_tail]; - _tx_buffer_tail = (_tx_buffer_tail + 1) % SERIAL_BUFFER_SIZE; - - *_udr = c; - - // clear the TXC bit -- "can be cleared by writing a one to its bit - // location". This makes sure flush() won't return until the bytes - // actually got written - sbi(*_ucsra, TXC0); - } } // Constructors //////////////////////////////////////////////////////////////// -- cgit v1.2.3-18-g5258