arduino-avr-xinput - A fork of Dmadison's Xinput Arduino avr core with a package.json

Age	Commit message (Collapse)	Author
2012-02-14	Leonardo now checks whether bootloader should be run after a WDT event.	Zach Eveland
	Before the sketch initiates an auto-reset for upload it pokes a magic word into a specific RAM address. On starting the bootloader checks this address. If it finds the magic word it knows the bootloader code should run. If not it jumps straight back to sketch. Test in a sketch by adding to setup(): wdt_enable(WDTO_2S); Sketch should upload, start, run for two seconds, WDT, and sketch should restart (not bootloader). Had to cut out unused descriptor code to make the bootloader still fit in 4k.
2012-02-14	Leonardo bootloader jumps straight to sketch for a power-on reset.	Zach Eveland
	Disconnect programmer after burning bootloader to get the full effect. ICSP and JTAG programmers do a hardware reset after any reset condition, confusing the firmware a little.
2012-02-07	fixed bug in Caterina which caused some programming instructions to fail	Zach Eveland
	Timer 1 interrupts were trashing self-programming timing. Now disable Timer 1 compare match before doing Flash tasks and reenable afterward.
2012-02-06	increased Leonardo bootloader timeout to 16 seconds	Zach Eveland

2012-02-03	proper bootloader timeout and LED control in Leonardo bootloader	Zach Eveland

2012-01-24	Caterina now cleanly hands off operation to the sketch	Zach Eveland
	had to remove TIMER1 operation from bootloader - was interfering with normal sketch operation
2012-01-21	move interrupt vector table to application section before jumping to it ↵	Zach Eveland
	after upload finished.
2012-01-21	Leonardo bootloader checks reason for reset and jumps immediately to sketch ↵	Zach Eveland
	if reset was caused by WDT
2012-01-19	stripped all LUFA LED control. from LUFA-based Caterina	Zach Eveland

2012-01-19	superficial changes to stock LUFA CDC bootloader - renamed project, removed ↵	Zach Eveland
	unnecessary files